Soundproofing of compressor compartment.

Hermetic compressor with crankcase heater.

Six poles condenser fan motor.

Electronic control panel.

Expansion device: thermal expansion valve.

Liquid receiver with outlet shut off valve complying with the provisions of the “Pressure Equipment Directive” 97/23/EC.

Liquid line including solid core filter and sight glass.

Fixed calibration low pressure switch with automatic reset. This outfit complies with the provisions of the “Pressure Equipment Directive” 97/23/EC.

Fixed calibration high pressure switch with automatic reset. This outfit complies with the provisions of the “Pressure Equipment Directive” 97/23/EC.

Liquid line solenoid valve.

Three-way valves on liquid line and suction line.

Pre-arrangement for room lighting connection.

Pre-arrangement for door switch connection.

Cable for door heater connection on all low temperature units.

Direct drainage of condensate.

Drain heater.

Floor-mounted condensing unit, ceiling-mounted evaporator.

Remote panel: already connected to the unit and provided with a 5 metres long connection cable (extension up to 20 metres on request).

Condensing unit suitable for outdoor installation. Recommended for use at ambient temperatures not lower than 10°C. Suitable accessories are required for use at temperatures below 10°C.

Optionals:

Special voltage.

Water-cooled condenser.

Voltage monitor.

Condenser fan pressure switch.

Condenser fan speed regulator.

Switchboard heater.